Stock 2 Failure to extract
Posted 19 December 2017 - 05:58 PM
Check extractor tension where the case sits when the barrel is unlocked. If you just slide a case up in the slide to check the tension it may falsely show it has good tension, slowly pull the slide back and see how low on the breech face a case is when it actually starts to extract the case. Then take it apart and check the tension at that spot, it will be much less than when checking it with the case pushed up in firing position. Also make sure the extractor is not sloppy in the slide or on the pin.
- Trigger Warning likes this
"I'm older and fatter than any of you dipshits."
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users